Since the beginning of this year, we have been offering a laser engraving service for pyramid marks.
The amount of penetration of Shinkiko energy seems to increase dramatically, and many people have used it so far.
Unfortunately, however, among various types of plates, such as thin large-sized plates and plate sheets, it was not possible to laser engrave those that had been treated with a laminated metal plate whose surface was covered with resin.
Since many people have these, I was trying to see if I could do something about it, but when I irradiated the laser with the same method as laser engraving on a metal plate, the laminate part melted due to the heat. It will fall apart.
Therefore, it is necessary to narrow down the laser output and weaken the light as much as possible, but if you do that, you will not be able to draw anything at all.
I have been trying through trial and error to find a boundary where I can engrave the pyramid marks without melting it due to heat, but it didn’t work out as I had hoped, so I gave up halfway.
At that point, Mr. A came to me and said, “I would like to laser engrave two thin large-sized plates.”
Since I already had two plates, I wanted to do something about it, so I turned the switch on again, and if that didn’t work, I thought I’d hand over a large plate, so I replied to the staff, “Let’s do something.”
However, although I have tried many times, I have not been able to get it to the level where I can sell it as a commercial product.
In the end, it was decided that Mr. A would receive the two thin large-sized plates and laser engrave the regular thick large plates.
Then, when it was time for Shinkiko at night, I suddenly had an idea.
“What if I applied pigment-based ink and engraved it?” I immediately bought two types of ink and tried gradually changing the intensity of the laser light, and at some point things started to get really good.
The pyramid mark can be engraved very neatly.
As with anything, even if things don’t go well, if you keep trying and don’t give up, at some point you will start to see the future.
In particular, it’s probably thanks to the powerful positive energy that things are going well so quickly.
Amidst the resistance of the negative energy that I didn’t want to be imprinted on, the positive energy that gathered together supported me, and I had a good idea.
Perhaps Mr. A’s ancestors had also helped him, and he was very grateful.
With this in mind, we have started a laser engraving service for pyramid marks on laminated products.
If you have the applicable product at home, please use it.
![](https://shinkiko.com/en-blog/wp-content/uploads/2024/08/大判切り抜きplate-1024x462.jpg)